Table of Contents
Advertisement
Installation Guide Linear Modules
8.2 Plain Bearing
The SM01 linear modules are available with linear ball bearings or plain bearings. Both types of bearings can
be replaced. The replacement interval of the bearings is determined by the function test of the linear guide.
See chapter 10.1.
8.2.1 Ordering Information
All 4 plain bearings should be replaced per linear module.
Item
Description
GL-A-2023-30
Plain bearings for the food sector 20x23-30 for SM01-37 Linear Modules
GL-A-3034-30
Plain bearings for the food sector 30x34x30 for SM01-48 Linear Modules
8.2.2 Mounting
Be sure to observe the safety instructions in chapter 2 during assembly!
NTI AG / LinMot
11. Screw the guide shafts tightly
(1) Push the guide shafts to the stop of the
guide block.
(2) Tighten the screws firmly.
Tightening torque: 18 Nm
12. Note the installation position of the plates
1. Loosen the guide shafts
(1) Loosen the screws of the guide shafts on
the front plate.
(2) Then push the guide shafts into the guide
block, but do not pull them out completely.
SM01-37 / SM01-48
If the guide does not move smoothly,
loosen the screws again and repeat
this step.
The front plate must be positioned on
the side of the connector and the back
plate on the opposite side.
The installation positions of the
mounting plates must not be
interchanged!
ENG
Item-No.
0160-3163
0160-3162
Page 29 / 85
Advertisement
Table of Contents
