Test Board; Disassembly; Assembly - Beckhoff XTS Operating Instructions Manual

7.3 Test board

7.3.1 Disassembly

7.3.2 Assembly

Version: 1.4
The test board is pre-mounted on the mover with two screws.
► Loosen screws [1] on the connector of the cable bridge
► Pull off the connector [2] of the cable bridge at the test board [3]
► Remove screws [1]
► Remove test board [2]
NOTICE
Note mover type
The test board may only be attached to AT9014-1070-x550
movers. All other movers are not suitable for mounting the NCT
electronics.
► Screw the test board [1] to the mover [3] with screws [2]
► Observe tightening torques:
Components
Screws, M6 x 20
XTS Starter Kit with NCT Functionality
Assembly and disassembly
Tightening torque [Nm]
4
─── 67