Adjust Air Gap - Beckhoff XTS Operating Instructions Manual

7.2.2 Adjust air gap

Reduce air gap
Version: 1.4
On both sides of the mover there is a set screw [1] for adjusting the
position of the NCT electronics. The air gap between the NCT elec-
tronics and the module can be adjusted using the two set screws.
NOTICE
Air gap must be at least 0.7 mm
To check the air gap, the mover must be on the guide rail. The air
gap must be at least 0.7 mm.
If the air gap is too small, damage to the mover and the system
may result.
► Loosen set screw [1]
Rotation Changing the air gap [mm]
1/4 0.1
► Tighten set screw [1] on the opposite side accordingly
► Check the air gap
If the air gap is not yet set correctly:
► Loosen and tighten the set screws again
OR
► Increasing the air gap
Further information can be found in chapter "Increasing the air gap",
[Page 64].
XTS Starter Kit with NCT Functionality
Assembly and disassembly
─── 63