Table of Contents
Advertisement
3.7 Product characteristics
Permanent magnets
Scalable travel path
Rail system
Armature short circuit brake
Integrated power electronics
Software-based control
Programming according to
IEC 61131-3
Version: 1.4
The permanent magnets used are made of a hard magnetic mate-
rial. The permanent magnets develop high forces even in small de-
signs. They enable the precise and highly dynamic positioning of the
movers.
The number of installed modules is variable. The length of the travel
path can be adapted to any application.
The best combination of several rail systems and movers can be se-
lected for each application.
In the case of an emergency stop the movers can optionally be de-
celerated by means of an armature short-circuit.
The entire power electronics is integrated in the modules. A 24 V
control voltage and a 48 V
modules.
The XTS is controlled by a software-based cascade control. The
control loop structure is stored in the XTS drivers and is calculated
cyclically on the control IPC. No additional drive software is re-
quired.
The standardized Motion Control function blocks according to the
PLC Open standard IEC 61131-3 are available for the programming
of the XTS.
XTS Starter Kit with NCT Functionality
Product overview
load voltage are required to supply the
DC
DC
───
31
Advertisement
Table of Contents
