Assembly and disassembly
Disassembly
7.1.2 Removing
60
───
► Insert rail on support [1]
► Insert screw [2] and hand-tighten it
► Note the position of the rail on support
► Remove screw [1]
► Remove rail on support [2]
► Insert end cap [1]
► Insert and tighten the screws [2]
► Observe tightening torques:
Components
Screw, M5 x 12
Screws, M3 x 14
► Remove the mover [1] via the rail on support [2]
XTS Starter Kit with NCT Functionality
Tightening torque [Nm]
2
1
Version: 1.4