Balanced 3-Phase Power Measurement - AEMC 205 User Manual

3.11.2 Balanced 3-Phase Power Measurement

1. Set the switch to
button until the desired choice is reached
2. Press the
The device automatically displays AC+DC. To select AC, DC, or
3.
AC+DC, press the
reached.
Connect the black lead to the COM terminal and the red lead to the "+"
4.
terminal.
5. Connect the leads and the clamp to the circuit as follows:
If the red lead is
connected...
To the L1 phase
To the L2 phase
To the L3 phase
NOTE: The arrow on the jaws of the clamp (see the diagram below) must point in
the presumed direction of flow of the current from the source to the load.
The measurement is displayed on screen.
NOTE: 3-phase power on a balanced 4-wire network can also be measured by
proceeding in the same way, or by proceeding as for the measurement on a
single-phase network, then multiplying the value by three.
and select VA, var, or PF by pressing the
(yellow) button until the
(yellow) button until the desired choice is
...and the black lead is
connected
to the L2 phase
to the L3 phase
to the L1 phase
29
symbol is displayed.
...then the clamp is on the
conductor
of the L3 phase
of the L1 phase
of the L2 phase