Table of Contents
Advertisement
User's Manual
NOTE: While the SSL function is enabled, the network transfer speed you selected may not be achieved.
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/).
LAN
Highlight the box beside Type and press the
or DHCP. Select the desired type and press the
Selecting Manual from the Type allows you to set up LAN parameters manually.
Change the numbers by highlighting them and using the Up and Down arrow buttons to increase or decrease the
number. The factory default LAN settings are:
IP Address:
192.168.1.129
Gateway:
192.168.1.254
Subnet Mask:
255.255.255.0
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.
Highlight the Port Number Setup... box and press the
NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,
Callback, Watch and Search) from your network administrator.
NOTE: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC running
RAS as well. Refer to the RAS manual for details.
42
Figure 28: Network – LAN setup screen.
button. You can select the type of network configuration from: Manual
button.
button. The Port Number Setup screen appears.
Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number. The factory default Port settings
are:
Remote Admin:
8200
Remote Callback: 8201
Remote Watch:
8016
Remote Search:
10019
Advertisement
Table of Contents
