Using The Switches On The Printerõs Rear Panel - Tektronix Phaser 220e Reference Manual

Using the switches on the printerÕs rear panel
Note
If you use the printerÕs rear panel switches, refer to the topic
ÒSharing the printer on a networkÓ in Chapter 10,
ÒTroubleshooting,Ó for details on how these switches interact with
the Tektronix driverÕs color correction settings.
You can use the printerÕs rear panel switches in different ways to set default
color corrections. A change to a switch setting takes effect immediately;
there is no need to reset the printer.
Using the switches alone (without a utility file)
To select no color corrections:
Phaser 220i: Place both Switches 8 and 9 in the down position.
Phaser 220e: Place Switch 3 in the down position.
To use the Vivid Blue color correction on the Phaser 220i:
Place Switch 8 up and Switch 9 down. This correction makes
printed blues look less purple.
(This setting does not apply to the Phaser 220e.)
To use the Simulate Press color correction on the Phaser 220i:
Place Switch 8 down and Switch 9 up. This correction makes
printed colors more closely resemble printing press output.
(This setting does not apply to the Phaser 220e.)
To use factory default color corrections:
Phaser 220i: If both Switches 8 and 9 are in the up position, the
factory default is Vivid Blue if no color correction utility Þle has
been downloaded.
Phaser 220e: If Switch 3 is up and Switches 1, 2, and 4 are down,
the factory default is Vivid Blue if no color correction utility Þle
has been downloaded.
Selecting Color Corrections
Printing Reference
6
6-11