Tektronix Phaser 220e Reference Manual page 113

PC and workstation users
1.
Copy the color sampler chart Þles that you want to use from the
SAMPLERS directory on the Printer Utilities diskette onto your
computerÕs hard disk. You may want to place these Þles in a
Utilities directory. Or, you can print these Þles directly from
the diskette.
2. Determine which color correction utility Þle you need to use by
examining the ÒDriver/File/SwitchÓ table.
3.
Send the appropriate utility Þle to the printer following
these steps:
a. Locate the color correction Þle you want in the PHSR220
directory on the Printer Utilities diskette.
b.
Use the DOS COPY command to send the color correction Þle
to the printer.
4. PC users: To print the color sampler charts, use the DOS COPY
command to send the sampler Þle to the printer.
Workstation users: To print the color sampler charts, send the Þle
to the printer.
5.
Select colors within an application using the colors on the chart.
6. If you are printing from a Tektronix driver: Print your document
using the Tektronix printer driver with the same color correction
option selected in the driver that you used to print the chart. Any
other color correction selection in the driver can cause the colors to
print differently.
If you are not using a Tektronix driver: Print your document
with the same color correction utility Þle sent to the printer that
you used to print the chart.
Selecting Color Corrections
Printing Reference
6
6-27