Tektronix Phaser 220e Reference Manual page 116

6
Selecting Color Corrections
6-30
Phaser 220 Drivers and Utilities
PC and workstation users
Note
If you donÕt want to use a utility Þle, you can place Switch 8 and
Switch 9 on the Phaser 220i, or Switch 3 on the Phaser 220e,
down for no color correction.
1. Copy the PANT220.PS sampler Þle from SAMPLERS directory on
the Printer Utilities diskette onto your computerÕs hard disk. You
may want to place this Þle in a Utilities directory. Or, you can print
this Þle directly from the diskette.
2. Send the NOCORECT.PS Þle to the printer.
a. Phaser 220i: Place both Switch 8 and Switch 9 in the up
position.
Phaser 220e: Place Switch 3 in the up position.
b. Locate the NOCORECT.PS Þle in the PHSR220 directory on the
Printer Utilities diskette.
c.
Use the DOS COPY command to send the Þle to the printer.
3. PC users: To print the PANTONE Color chart, use the DOS COPY
command to send the sampler Þle to the printer.
Workstation users: To print the PANTONE Color chart, send the
Þle to the printer.
4. Select PANTONE Colors within an application using the colors on
the chart.
5. If you are printing from a Tektronix driver: Print your document
with the None option selected. Any other color correction
selection in the driver will cause the PANTONE Colors to print
differently.
If you are not using a Tektronix driver: Print your document
with no color correction on a Phaser 220i with Switches 8 and 9 in
the down position (Switch 3 in the down position on a Phaser 220e).