Tektronix Phaser 220e Reference Manual page 19

Using the LaserWriter Utility to send files to the printer
The LaserWriter Utility is an Apple utility that you use on the Macintosh to
send PostScript Þles and fonts to the printer.
The following Þles are not self-sending; use the LaserWriter Utility to send
these Þles to the printer:
¨
PANTONE -Tek Phaser 220 (PANTONE color sampler chart)
Reset Printer
1. Decompress the Phaser 220 Utilities.sea archive Þle on the
Macintosh Printer Utilities diskette to a folder on your
hard disk.
2.
Install the Tektronix driver according to instructions in Chapter 2,
ÒPrinting from a Macintosh.Ó
3. Select the appropriate printer in the Chooser.
4. Locate the LaserWriter Utility in the folder of decompressed Þles.
Double-click on the LaserWriter Utility icon to start
the application.
5. Select Download PostScript File from the Utilities menu.
6. Select the Þle that you want sent to the printer, and click Open.
7.
At the prompt Save PostScript output as: you are asked
for a Þle name for saving printer output. Use the default name
given in the edit box or type in a new name. Then click Save to
send the Þle to the printer. (Printer output includes status
messages generated by the printer reporting such conditions as
out of paper.)
8. If no output is returned by the printer, the LaserWriter Utility
displays a dialog box; click OK in the box to continue.
If output is returned by the printer, you won't see this dialog box;
check your hard disk for the Þle the utility created for the
printer's output.
Before You Begin
Printing Reference
1
1-9