Testing Printer Language Mode Change; Hp-Gl Mode; Postscript Mode; Setting Default Hp-Gl Pen Colors - Tektronix Phaser 220e Reference Manual

9
Using Different Printer Language Modes

Testing printer language mode change

HP-GL mode

PostScript mode

Setting default HP-GL pen colors

9-6
Phaser 220 Drivers and Utilities
HPGLTEST.PLT is an HP-GL Þle that prints a single line of text if the printer
is operating in HP-GL mode.
Send this Þle to the printer (with the DOS COPY command) after you send
HPGL.PS to make sure that the change was made correctly.
PSTEST.PS is a PostScript Þle that prints a single line of text if the printer is
operating in PostScript mode.
Send this Þle to the printer (with the DOS COPY command) after you send
PSCRIPT.PS to make sure that the change was made correctly.
The HPGLPENS.PS Þle changes the color and width of the default pen
colors. The HP 7475A plotter actually has only six pens, but the printer's
emulation supports up to 256 pens.
Note HP-GL pen settings cannot be made persistent across power
cycles; pen settings revert to the default when the printer is
turned off.
In HPGLPENS.PS, pen number, pen width, red value, green value, and blue
value are listed in parentheses after /ColorSetup as shown below.
/ColorSetup (pen_number width red_value green_value
blue_value...)