Tektronix Phaser 220e Reference Manual page 151

To change CONFIG.PS to specify different timeouts, substitute
new values for 0 and 40 in the JobTimeOut and WaitTimeOut
lines. Permitted timeout values are as follows:
JobTimeOut: 0 to 999
WaitTimeOut: 0, or 15 to 999
To specify no timeout, use 0
In the following example, the timeouts are set to their
default values.
<< /Password
/JobTimeOut
/WaitTimeOut
>> setsystemparams
4.
Use the DOS COPY command to send CONFIG.PS to the printer.
If the printer is connected to a parallel (LPT) port, enter the
following command:
COPY CONFIG.PS LPTX:
where X is the number of the parallel port. If the printer is
connected to a serial (COM) port, enter the following command:
COPY CONFIG.PS COMX:
where X is the number of the serial port.
Using Different Printer Language Modes
()
0
40
Printing Reference
9
9-3