How To Attach And Detach Additional Units - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.13. How to Attach and Detach Additional Units

When attaching or detaching additional units (LED unit, Buzzer unit) to this product, be sure to follow the steps below.
The maximum number of attachments for each unit: 1 x this product + 5 x LED units + 1 x buzzer unit. Do not attach units
beyond that.
When LED and buzzer units are attached, operate with an input voltage from 21.6 to 26.4 VDC.
Do not attach a WD transmitter due to possible radio interference effects.
Do not apply excessive force to this product and to each unit. Failure to follow this instruction could result in equipment
damage.
Do not touch the connectors on this product and on each unit as well as LEDs in LED units. Failure to follow this instruction
could result in equipment damage.
Securely lock each unit when attaching. Failure to secure units could result in product damage.
Attach or detach additional units, in order, one at a time. Any other method may result in damaging additional units.
When using the transmitter's flashing COM to control the receiver's buzzer unit, set the DIP switch to [Continuous beep].
● How to attach and detach
Head Cover
WIO Body Unit
Rotate the head cover
counterclockwise to
unlock and remove.
● Positioning
<Locked>
Condition when locked
<Unlocked>
Condition when unlocked
Additional units
WIO Body Unit
While aligning with the While aligning with the
positioning mark, insert positioning mark, insert
the additional unit and the head cover and turn
turn clockwise to lock. clockwise to lock.
Align and fit the positioning marks and turn clockwise to lock.
While holding the adjacent lower unit, turn the unit to be
removed counterclockwise to unlock it and lift it up.
CAUTION
Head Cover
73
7. Operation