Wiring; Detaching The Terminal Block Connector; Wiring Caution - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.11. Wiring

7.11.1. Detaching the Terminal Block Connector

To remove the terminal block, turn the terminal block connector screws (2 places) counterclockwise and pull out the
terminal block connector. To install the terminal block, line up the guide marks on the WIO body unit and terminal block
connector, and follow the removal procedure in reverse order to install.
Recommended Torque
● Use a flat-blade screwdriver with a blade-edge width of 2.5 mm or less and a thickness of 0.4 mm or less. (Or equivalent)

7.11.2. Wiring Caution

When securing the lead wire, secure with extra wire length. If there is insufficient extra cable length, it could prevent you
from removing the WIO body unit from the direct mount bracket.
WIO Body
Unit
Direct
Mount
Bracket
(View of WIO Body Unit from the bottom)
Guide mark
WIO Body Unit
side
Terminal Block
Connector side
0.2 N・m
Cable
As there is sufficient extra
cable length, you can detach
the WIO body unit.
Guide mark
WIO Body Unit
side
Terminal Block
Connector side
Point
CAUTION
WIO Body
Unit
Direct
Mount
Bracket
46
7. Operation
Cable
If there is insufficient extra
cable length, it could prevent
you from removing the WIO
body unit.