Operation ＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿19; Procedure Up To Operation - Patlite WIO-B1T Instruction Manual

Wireless Control Unit
7. Operation

7.1. Procedure up to Operation

• Please familiarize yourself with "6. For Proper Use of This Product" ( ☞ page 16) before operating this product.
• This section describes the procedure required to start operating this product. Follow the steps below to prepare
operating this product. Perform STEP 1 to STEP 7 on the transmitter, receiver, and repeater.
Preparation of necessaryequipment
１
STEP
and evaluation of communication configuration
２
STEP
Setting
３
STEP
Temporary installation
*
4
STEP
Pairing
5
STEP
Verify communication
６
STEP
Installation
７
STEP
Start operation
* If the communication check results show that the signal is poor and the installation location needs to be reconsidered, start over from STEP 3.
Set this product to match its usage.
・"7.3.1. Group ID Setting" ( ☞ page 22)
・"7.3.2. Function Settings" ( ☞ page 24)
・"7.4. Functions" ( ☞ page 26)
Perform temporary installation of this product.
・"7.7. Using a Repeater" ( ☞ page 34)
・"7.10. Mounting" ( ☞ page 42)
・"7.11. Wiring" ( ☞ page 46)
・"7.12. Wiring Example" ( ☞ page 54)
・ Install this product in a location with good visibility.
"6.4. Radio Influence and Interference in Installation Environments" ( ☞ page 18)
・Install this product Temporary installation can be easily
performed by using a mounting bracket (SZW-003W)
and AC adapter (ADP-001C).
Perform pairing and check the signal status. Add a repeater if required.
・"7.5. Pairing" ( ☞ page 30)
・"7.6. How to Unpairing" ( ☞ page 33)
・"7.7.3. Adding a Repeater After Temporary Installation" ( ☞ page 35)
Confirm communication with the status of the indicator lights.
・"7.8. Checking the Indicator" ( ☞ page 37)
If wireless quality is poor, reconsider the installation location or add a
repeater. When using a repeater, turn on the power starting from the
transmitter."7.7.1. How to Switch the Repeater ON/OFF" ( ☞ page 34)
Install and wire this product.
・"7.10. Mounting" ( ☞ page 42)
・"7.11. Wiring" ( ☞ page 46)
・"7.12. Wiring Example" ( ☞ page 54)
Turn on this product and start operations.
19
7. Operation