Function Settings; How To Set Functions - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.3.2. Function Settings

This product has "Level Mode," "One-shot Mode", and "input logic switching" functions.
Assign functions by turning this product's Function DIP switch ON and OFF. For details on how to set functions,
refer to "7.3.2.1. How to Set Functions".
● "Level Mode" is recommended for the following usage conditions.
• When using alternating-type switches, such as toggle switches
• When inputting from a PLC or other device in the equipment
● "One-shot Mode" is recommended for the following usage conditions
• When using momentary switches such as pushbutton switches
• When using a sensor that outputs only at the moment of detection

7.3.2.1. How to Set Functions

• Turn DIP switches No.1 to 3 ON or OFF to set functions.
• Read "7.2. About the DIP Switches and Reset Button" ( ☞ page 20) before handling the DIP switches.
❶
Confirm the product to set is turned off.
❷
Remove the head cover from the WIO body unit.
❸
Set the Function DIP switch.
• For details on each function, refer to "List of Functions
for the Function DIP Switch" in the next section.
• Do not use switch No. 4.
❹
Attach the head cover to the WIO body unit.
Point
❸
Function DIP Switch
24
7. Operation
Head Cover
❷
❹
WIO Body
Unit