Patlite WIO-B1T Instruction Manual page 32

Wireless Control Unit
● How to Pair the Receiving Product
❻
Confirm the receiving product is turned off.
❼
Remove the head cover from the WIO body unit.
❽
Set the Group ID DIP Switch.
• The switch No. of the Group ID DIP Switch should
match the transmitting product to be paired.
If the switch No. does not match, pairing will not
occur.
• Specify the Group ID from 1 to 8.
For information on how to allocate each group ID,
refer to "7.3.1.1. How to Set the Group ID" ( ☞ page 23).
❾
Attach the head cover to the WIO body unit.
❿
Turn on the receiving product and confirm that
the indicator is lit blue.
ㅣ The indicator lights up blue when the receiving product
is ready for pairing.
● Common (Transmitting and Receiving Products)
⓫
Confirm the indicators on the transmitting and
receiving products are lit green.
• When pairing is complete, the indicator changes from
lit blue/flashing blue to lit green.
• If the blue light continues to flash/light up for awhile,
the installation environment may be poor, such as
the group ID being incorrect or the sending/receiving
product being out of range. Please reconsider the
installation location.
• If the receiving product is a repeater, the indicator will
change to flashing blue after pairing is complete.
● When the relay function of the receiver at the end of the line is turned on, the product can be used as a repeater.
- Receiving product -
❽
Group ID DIP Switch
❿
Indicator
Blue light on
Ready for pairing
- Transmitting product -
⓫
Point
32
7. Operation
Head Cover
❼
❾
- Receiving product -
Indicator
Green light on
Pairing complete
WIO Body
Unit