Checking The Indicator - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.8. Checking the Indicator

Check the indicator status with its lighting.
Transmitter
Products
Category
Transmitter Repeater
Starting up
●
●
Pairing
-
●
●
●
●
●
Operation
-
●
●
Alarm
●
Repeater
Indicator
Light Status
Receiver
Lemon light on
● ●
Flashing blue
● -
Blue light on
● ●
Green light on
● ●
Amber light on
● ●
Red light on
● ●
Pink light on
● ●
Flashing green
Flashing amber
- -
Flashing pink
Flashing green
Flashing amber
● ●
Flashing pink
Light blue light on
- -
Alternating
● ●
Red↔ Green
Flashing red
● ●
Repeater Repeater
Status
Starting up After turning ON the power, in the start up state.
After turning ON the power, in the state where the
connection information (pairing information) is not
Pairing
registered.
Searching for a connection point.
Wireless quality is good.
Wireless quality is poor.
Reconsider the installation location or install a
repeater.
Waiting for wireless connection.
Wireless
Registration of connection information (pairing
quality
information) has completed.
Wireless connection to the destination is
established, but wireless connections between
other products in the system are not established.
Registration of connection information (pairing
information) has completed.
Flashes when the contact detects an input.
(flashes green when the wireless quality is good,
amber when it is poor, and pink when the wireless
connection to the destination is established but not
between other products in the system)
Flashes when a contact is output.
(flashes green when the wireless quality is good,
amber when it is poor, and pink when the wireless
connection to the destination is established but not
Operation
between other products in the system)
Status
When the input detected by the transmitter
reaches the receiver, it lights up light blue for
about 1 second (answerback).
In order to periodically check the communication,
it may light up in light blue even if it is not an
answerback.
Operating in unpairing mode.
When a fourth repeater is attempted to be added
in the system, the indicator of the repeater flashes
Error
red.
Status
If the flashing status continues, an error has
occurred in the product.
37
7. Operation
Receiver
Contents