Input Logic A/B Switching Setting - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.4.3. Input Logic A/B Switching Setting

• Select for this product the logical sum of the transmitter product's ON/OFF input and the receiver product's
ON/OFF output [Input Logic A (NO Contact)], and the inverse logic of the transmitter product's ON/OFF input
and the receiver product's ON/OFF output [Input Logic B (NC Contact)].
• Read "7.2. About the DIP Switches and Reset Button" ( ☞ page 20) before handling the DIP switches.
● When using input devices (sensors, switches) with a B contact, it is recommended to set "Input Logic B (NC contact)".
For setup, refer to "7.3.2.1. How to Set Functions" ( ☞ page 24).
If the input logic is set to B and the LED unit/buzzer unit is installed, it will be performed as follows.
Transmitter side: When ON is input, LED unit/buzzer unit lights up/operates.
Receiver/repeater side: When OFF is input, LED unit/buzzer unit lights up/operates.
Transmitter
Setting
Function
DIP Switch
OFF
ON
OFF
ON
Repeater
Function
DIP Switch
OFF
ON
Receiver
Function
DIP Switch
OFF
ON
ON Input
OFF Input
ON Input
OFF Input
ON output
OFF output
ON output
OFF output
Point
29
7. Operation