When Using Repeaters From Temporary Installation; Adding A Repeater After Temporary Installation - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.7.2. When Using Repeaters from Temporary Installation

• When using repeaters from when installation was performed, turn on the power from the transmitter, in turn,
and pair as follows.
• For products that are not paired, turn off the power.
Transmitter
Paring 1

7.7.3. Adding a Repeater After Temporary Installation

• If wireless quality is poor after temporary installation, consider installing a repeater. At that time, if the indicator
light is amber, the repeater can be added simply by turning the repeater ON.
• A repeater can be added between products by simply turning on the repeater only when all of the following
conditions, ① through ③ , are met.
① Connection information (pairing information) between products is registered.
② The wireless connection between the products is not in good condition (indicator light is amber) (Refer to "7.8.
Checking the Indicator" ( ☞ page 37))
③ The number of repeaters within a single group does not exceed 2 units.
Amber light on
Wireless quality is poor
Transmitter
Green light on Green light on
Wireless
quality is
good
Transmitter Repeater
Add a repeater
Repeater Repeater
Paring 2
Add repeaters one at a time. Adding two or more repeaters at the
Amber light on
same time may cause connection problems.
When eliminating the installation of a repeater after the addition
of a repeater, unpair the transmitter and receiver, and pair
again. Turning off the repeater does not restore the connection
environment prior to the addition of the repeater.
Repeater / Receiver
A repeater may be unintentionally paired with products when
product systems exist under the following conditions. Please use
caution.
・ There are products (indicator light is amber) in close proximity
Green light on
・ Products that are in the middle of pairing are in close proximity
Wireless
quality is
good
● Connect via the added repeater.
Repeater / Receiver
● Add one repeater between the paired transmitter and receiver/repeater,
● When the indicator light is amber, the repeater can be connected
Repeater
Paring 3
CAUTION
that do not have a good wireless connection between products
or between the paired repeater and receiver/repeater.
regardless of whether its group ID is a match or mismatch.
35
7. Operation
Receiver
Paring 4
Point