Wireless Control Unit
7.10.2. Mounting with Mounting Bracket (Option)
❶
Determine how to secure the mounting bracket.
When securing with screws
As shown in the illustration below, drill mounting holes at the installation location.
* Screws (M4 or nominal diameter 4) to secure the bracket are not
included. Please provide your own. (bracket thickness: 7 mm)
❷
Attach the grommet to the mounting bracket's wiring hole (rear).
* Either wiring hole (rear) can be used.
Use both wiring holes, if necessary.
* A cable gland can be used instead of a grommet (accessory) to prevent
dust from entering the mounted product through the wiring holes. (Cable
gland mounting hole diameter: φ 16.5, mounting plate thickness: 1.5 mm,
outer diameter: φ 26 mm or less for the mounting portion.)
❸
Pull wires out the grommets and attach the direct mount
bracket to the mounting bracket.
❹
Secure the product to the mounting bracket with hexagon nuts (M4).
Recommended Torque
* For the installation method of each product mount, refer to
the corresponding product's instruction manual.
* Hexagon nuts (M4) are not included with this product.
Use the hexagon nuts that are attached to each product.
❺
Pass the wire through the wiring hole.
❻
Remove the two screws from the terminal block connector
and perform the wiring.
• Refer to "7.11.1. Detaching the Terminal Block Connector" ( ☞ page 46)
• Refer to "7.11.3. Wiring the Terminal Block Connector" ( ☞ page 47)
❼
Attach the terminal block connector to the WIO body unit.
• Refer to "7.13. How to Attach and Detach Additional Units" ( ☞ page 73)
❽
Secure the mounting bracket to the installation location.
When securing with screws
Secure the mounting bracket with screws (M4 or nominal diameter 4).
* When using a flat washer for mounting, use one with a diameter of
φ 10 mm or less.
Mounting Hole
( 5 x 4 places)
105
(Unit: mm)
0.6 N・m
When securing with adhesive sheet
Peel away the yellow non-stick paper from the adhesive sheet and stick it
to the location for the adhesive sheet.
Location for
Adhesive Sheet
Application
WIO Body
Unit
Direct
Mount
Bracket
❸
Mounting Bracket
Hexagon Nut (M4)
When securing with adhesive sheet
Peel off the transparent protective film and secure the mounting
bracket.
43
7. Operation
Location for
Adhesive Sheet
Application
❻❼
Wiring
Wire Distribution Hole
(Top)
Wire Distribution Hole
(Back)
❷❺
Grommet
(accessory)
❹