Operation - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

5.3. Operation

This product works in conjunction with the following.
Answerback
When the input information
of the transmitter is
successfully sent to the
receiver, it lights up in light
blue for 1 second.
■ Receiver's Contact Outputs Corresponding to the Transmitter's Contact InputsContact Input
The receiver's contact output corresponding to the transmitter's contact input is as follows.
■ LED Unit / Buzzer Unit Corresponding to Each
When a signal is input to the transmitter's contact input (CH1-6, buzzer), the LED unit/ buzzer unit connected to
the transmitter/ receiver is also activated.
The LED unit/buzzer unit corresponding to each contact input is as follows.
Maintain the input signal status for 100 ms or longer.
Input signals shorter than 100 ms may not be detected.
When using the transmitter's flashing COM to control
the receiver's buzzer unit, set the DIP switch to [Continuous beep].
Transmitter
Contact input
CH1 (LED Unit Red)
CH2 (LED Unit Amber)
CH3 (LED Unit Green)
Input
CH4 (LED Unit
CH5 (LED Unit White)
CH6
Buzzer
Each Contact Input
* When using the transmitter's flashing COM
to control the receiver's buzzer unit,
set the DIP switch to [Continuous Beep Sound].
Bluetooth wireless
Additional Units
CH1 LED Unit Red
CH2 LED Unit Amber
CH3 LED Unit Green
CH4 LED Unit Blue
CH5 LED Unit White
CH6 (None)
Buzzer Buzzer Unit
CAUTION
Transmitter
CH1 - CH6,
Buzzer
15
5. Product Overview
Receiver / Repeater
Contact output
CH1
CH2
Non-Voltage
CH3
Contact Output
Output
CH4
CH5
CH6 Relay output
(None)
100 ms or longer 100 ms or longer