One-Shot Output Clear - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.4.2.1. One-shot Output Clear

• When operating in One-shot Mode, the output continuous state can be canceled by the receiving product.
• To cancel the output continuous state, execute Clear Input (OFF→ON) to the receiver or repeater that is
maintaining the output.
• Read "7.2. About the DIP Switches and Reset Button" ( ☞ page 20) before handling the DIP switches.
Transmitter
Function
DIP Switch
Repeater
OFF
ON
OFF
ON
Function
DIP Switch
OFF
Receiver
ON
OFF
ON
● One-shot Output Clear operates independently for each product. (One-shot Output Clear of the repeater and of the
receiver are not linked.)
● One-shot Output Clear is detected as input OFF→ON (detection timing shown in the figure).
● This function can be operated only in One-shot Mode and not in Level Mode.
ON
ON Input
OFF Input
Setting
ON output
OFF output
ON output
OFF output
ON Input
OFF Input
Setting
ON output
OFF output
ON output
OFF output
ON Input
OFF Input
ON
12 seconds
Detection timing
12 seconds
Detection timing
Point
28
ON
12 seconds
Detection timing
12 seconds
Detection timing
7. Operation