Table of Contents
Advertisement
Wireless Control Unit
7.7. Using a Repeater
• If the wireless quality is poor due to distance or obstacles between products, the wireless quality may be improved
by installing a repeater.
• This product can be used as a repeater by changing the receiver settings.
• Up to three repeaters can be installed in one group.
• The output of the repeater and the output of the receiver are linked.
Transmitter
● The system must consist of one transmitter, 0 to 3 repeaters, and one receiver.
● Four or more repeaters cannot be connected and used.
● A repeater is identified as a separate device from the receiver, so there must always be one receiver per group.
● Transmitters do not posses the relay function.
● If the product is replaced for maintenance, cancel the pairing of each product and perform pairing again from the
transmitter side.
7.7.1. How to Switch the Repeater ON/OFF
• To use the receiver as a repeater, switch the Repeater Setting Switch to ON.
• Before switching the Repeater Setting Switch, turn off the power to the repeater.
• Read "7.2. About the DIP Switches and Reset Button" ( ☞ page 20) before handling the Repeater Setting Switch.
❶
Confirm the repeater is turned off.
❷
Remove the head cover from the WIO body unit.
❸
Change the Repeater Setting Switch.
❹
Attach the head cover to the WIO body unit.
Up to 3 can be installed
Repeater
Repeater
Point
Repeater
❸
OFF
ON
Repeater Setting Switch
34
7. Operation
Receiver
Head Cover
❷
❹
WIO Body
Unit
Advertisement
Table of Contents
