How To Add A Repeater - Patlite WIO-B1T Instruction Manual

Wireless Control Unit

7.7.3.1. How to Add a Repeater

• When the indicator light is amber, a repeater can be added between products simply by turning on the repeater
to be added (simple add function).
• Read "7.2. About the DIP Switches and Reset Button" ( ☞ page 20) before handling the Repeater Setting Switch.
• Follow the steps below.
❶
Confirm the repeater is turned off.
❷
Remove the head cover from the WIO body unit.
❸
Turn on the Repeater Setting Switch ON.
❹
Attach the head cover to the WIO body unit.
❺
Turn on the repeater.
• The indicator light of the repeater is blue.
• Pairing is initiated while the indicator light on
the repeater is blue for approximately 30 seconds.
ㅣ If the indicator light changes from amber to green,
during the approximate 30 seconds of inactivity,
the repeater will not initiate pairing.
ㅣ The indicator light flashes blue when pairing is initiated.
If the blue light continues flashing for awhile,
the receiving product may not be within range of
the radio wave. Reconsider the installation location.
ㅣ When the addition of a repeater is completed,
the indicator light turns red, followed by green.
❻
Confirm that pairing is complete and the indicator
light is green.
When eliminating the installation of a repeater after the addition of a repeater, unpair the transmitter and receiver, and
pair again. Turning off the repeater does not restore the connection environment prior to the addition of the repeater.
A repeater may be unintentionally paired with products when product systems exist under the following conditions.
Please use caution.
・ There are products (indicator light is amber) in close proximity that do not have a good wireless connection between products
・ Products that are in the middle of pairing are in close proximity
Depending on the installation environment or signal conditions, or if the product's power is turned off during addition,
the indicator may not turn green even after about 2 minutes have passed since the power of the repeater to be added
is turned on, and addition may not be possible. In that case, please follow the steps below.
・Review the communication environment of the repeater to be added.
・If the indicator of each product does not return to the state before the repeater was added, cancel the pairing of
all products and perform pairing again from the transmitter side.
- Repeater -
❸
Repeater Setting Switch
❻
Addition complete
CAUTION
36
Head Cover
❷
Indicator
Green light on
7. Operation
❹
WIO Body
Unit