Mitsubishi Electric MELSEC iQ-R Series User Manual page 225

■Backup
The information of "Total number of times" and "Total time" of each 'Data logging setting' is stored in the computer from the
currently running high speed data logger module.
By backing up the total number of times and the total times before replacing an SD memory card, these two pieces of
information can be obtained after exchanging the card.
Operating procedure
1.
Click the [Backup] button on the "Diagnostic" screen to data logging diagnostics.
2.
On the "Save as" screen, specify the save location and file name and then click the [Save] button.
■Restore
Reflects the information of "Total number of times" and "Total time" stored on the computer, in the currently running high speed
data logger module.
Operating procedure
1.
Click the [Restore] button on the "Diagnostic" screen to data logging diagnostics.
2.
Select the file to be opened on the "Open" screen, then click the [Open] button.
Precautions
• Restore operation is executed irrespective of high speed data logger module settings. Because of that, no any error occurs
in high speed data logger module in operation even if there is no 'Data logging settings' including "Total number of times"
and "Total time."
• The information of "Total time" and "Total number of times" are saved in the 'Data logging settings' unit. Restore the data
when settings same as the high speed data logger module that executes backup, are configured.
2 HIGH SPEED DATA LOGGER MODULE CONFIGURATION TOOL
2
223
2.8 Online