HPE Nimble Storage HF Series Hardware Manual page 44

Clicking OK closes the setup manager, and continues the setup on the array through your web browser.
4. You might see a warning similar to There is a problem with this website's security certificate. You can safely ignore this
warning and click Continue.
If prompted, you can also download and accept the security certificate. Or create your own security certificate. Refer to
the cert command in the Command Reference.
Note: If Internet Explorer 11 displays a blank page, clear the browser's cache. The page should be visible after
refreshing the browser.
5. In the License Agreement, read the agreement, scroll to the bottom, check the acknowledgment box, and then click Proceed.
6. In the Array Setup, choose the appropriate group option and click Next.
Set up this array but do not join a group. Continue to the next step.
Add this array to an existing group. Enter the IP address of the group.
If you chose to join an existing group, your browser redirects to the login screen of the group leader array. Refer to
the GUI Administration Guide or the CLI Administration Guide for steps on how to add an unconfigured array to a
group, and complete the configuration.
7. Provide or change the following initial management settings and click Finish:
Array name
Group name
Management IP address and subnet mask for the eth1 interface
Default gateway IP address
Domain name
(Optional) Administrator password
8. After a successful setup, click Continue.
Your browser automatically redirects to the Management IP address of the array.
Note: If the array does not initialize, check the cabling to the network switch and check the subnet mask.
9. In the login screen, type the password you set and click Log In.
From this point forward, you are in the operating system GUI.
10. Provide the Subnet Configuration information for the following sections and click Next:
a) Management IP:
IP address
Network
Subnet mask
Note: The Management IP is used for the GUI, CLI, and replication. It resides on the management subnet and
floats across all "Mgmt only" and "Mgmt + Data" interfaces on that subnet.
b) Subnet:
Subnet label
Network
Netmask
Traffic Type – Data only
Traffic Assignment (This field is hidden if you are running a Fibre Channel array)
Discovery IP (This field is hidden if you are running a Fibre Channel array)
IP Address Zone – Single, Bisect, or Even/Odd (This field is hidden if you are running a Fibre Channel array)
Maximum Transmission Unit (MTU) – Standard, Jumbo, or Custom
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Install the HPE Storage Array 44