Add And Assign The Array To Data Services Cloud Console - HPE Nimble Storage HF Series Hardware Manual

7. Leave the Limit Resource Access option disabled..
8. Click Assign Role.
9. Click Change Role Assignment to confirm the assignment.
10. Back on the Identity & Access page, click the Users card.
11. Find the user, and select View Details from the corresponding more ( ) menu. Verify that the user has the correct
permissions.
12. In the HPE GreenLake menu bar, click Applications.
13. Click Data Services Cloud Console.
14. Click Launch.
15. Verify that the following Data Services Cloud Console services are available:
Setup Service
Block Storage
Data Ops Manager

Add and Assign the Array to Data Services Cloud Console

To manage the storage array, you must add and assign it to Data Services Cloud Console.
Before starting, verify that you received an email with the array serial number and subscription key. You will need both to add
the array to Data Services Cloud Console. If you do not have this information, skip this procedure until you obtain it. Consider
the following resources:
The array serial number is also located on the rear of the array, on either a pull-out tab, or a label.
Later in the initial setup process, when you are connecting the array to HPE GreenLake, the Cloud Connectivity Wizard
will display the subscription key.
The method for performing this operation depends on whether the array is owned or subscribed.
Add and Assign an Owned Array
Procedure
1. On the HPE GreenLake menu bar, click Devices.
2. Click Add Devices.
3. Select Storage Devices as the Device Type, then click Next.
4. Select Purchase or Lease as the Ownership Type.
5. Type the array Serial Number and Subscription Key, and then click Enter. Repeat this step for each additional array.
Click Next when done.
6. Optionally assign tags to the storage array. Tags are used to organize/label inventory resources. Click Next.
7. Verify your settings, then click Finish.
8. In the Inventory list, select the array that you just added, then select Assign to Application.
9. Select Data Services Cloud Console for the Application, and then select the Application Instance closest to where you
have Data Services Cloud Console installed. Click Finish, and then Close.
10. Back on the Inventory page, verify that the array is listed and that it is assigned to the correct Data Services Cloud Console
instance.
Add and Assign a Subscribed Array
Procedure
1. Add the array subscription key:
1 On the HPE GreenLake menu bar, click Manage.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Install the HPE Storage Array 36