Replace A Pcie Card; Guide Pins 2 Riser Card - HPE Nimble Storage HF Series Hardware Manual

1 Guide pins
c) Tighten the bottom thumbscrew.
5. Return the controller shroud into place if you removed it to access the PCIe cage.
a) Align the notches in the shroud (marked by arrows) with the pegs on the controller.
b) Lower the shroud into place. Make sure the tabs on the shroud seat properly in the controller.
6. Install the replacement controller.
a) Make sure the controller release lever is fully extended.
b) Slide the replacement controller into the chassis bay. Do not force the controller. If it does not slide in easily, remove
it and retry.
c) After the new controller is in place, return the controller release lever to its original closed position until the catch
clicks, and then tighten the thumbscrew.
d) Reconnect all the cables to the new controller (as labeled from step 2).
7. Verify that the new controller is powered on.
Once installed, the replacement controller powers on automatically. The controller LEDs on both the left and right side of
the array remain on. If the controller does not power on automatically, contact HPE Support.
Note: If firmware updates are required, the new controller can take from 15 to 45 minutes to appear in the UI. If
the controller takes longer than 45 minutes to report an Active/Standby state, contact HPE Support for assistance.
8. Return the failed controller as directed on the RMA work order.

Replace a PCIe Card

Use this procedure to replace existing network interface cards (NICs), host bus adapters (HBAs), or storage class memory
(SCM) on your HPE storage array.
Note: SCM is available for AF60 and AF80 model arrays.
2 Riser card
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Maintenance Procedures 87