Restart The Array; Array Leds - HPE Nimble Storage HF Series Hardware Manual

Restart the Array

You must use the CLI to restart the array.
CAUTION: When you restart the array, all volumes temporarily go offline.
Procedure
1. Determine the name of the array.
array --list
The name of the array appears in the list.
2. Reboot the array.
reboot --array array name

Array LEDs

The array front LEDs are located on both handles. The power button and power supply status LED are only on the right handle.
Figure 21: Front LEDs
1 Power button
2 Power supply status
3 Controller ID button
The following table describes the front LEDs.
LED
Power button
Power supply status
4 Controller status
5 Controller power
Status
Solid green indicates that the power is on
Solid green indicates that input from the installed power
supplies is within range
Amber indicates that power is out of range
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Array Components 54