Changing Parameters And Values - Swann AMI Codes-II Operator's Manual

AMI Codes-II
Operation
5.4.
Changing
parameters
Changing
values
A-96.250.571 / 050517

Changing Parameters and values

The following example shows how to change the logger interval:
Logger Sensors
Sensor type
Log interval
Disinf. Free chlorine
Clear logger
Temperature
Standards
Logger
Interval.
Log interval
Clear logger 5 min
10 min
30 min
1 Hour
Logger
Log interval
Clear logger
Logger
Log interval
Save ?
Clear logger
Yes
No
Alarm DIS
Alarm High 5.00 ppm
Alarm Low 0.00 ppm
Hysteresis 1.00 ppm
Delay
Alarm DIS
Alarm High 0.20 ppm
Alarm Low 0.00 ppm
Hysteresis 1.00 ppm
Delay
1 Select the parameter you want to
4.4.1 5.1.2
change.
FOME
30 min
2 Press [Enter]
no
NT5K
3 Press [
4.1.3
highlight the required parameter.
30min
4 Press [Enter] to confirm the selec-
no
tion or [Exit] to keep the previous
parameter).

The selected parameter is
4.1.3
highlighted but not saved yet.
10 min
5 Press [Exit].
no

Yes is highlighted.
4.1.3
6 Press [Enter] to save the new pa-
rameter.
no

The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
2 Press [Enter].
3 Set required value with [
5 Sec
[
4 Press [Enter] to confirm the new
5.3.1.1.1
value.
5 Press [Exit].

Yes is highlighted.
5 Sec
6 Press [Enter] to save the new val-
ue.
] or [ ] key to
] key.
] or
41