Assembling The Stand - Canon imagePROGRAF iPF8000S Service Manual

3.1.2.2 Assembling the Stand

- Stand assembly requires two or more people working on a flat floor. Assembling the stand alone may cause injury or accidental bending of the stand.
- Stand casters are locked at the time of factory shipment. Do not release the lock until the stand has been fully assembled. In addition, release the lock before moving
the stand. Moving the stand while the casters are locked may scratch the floor or cause injury.
1) Position the left stand leg and right stand leg so that the markings on the bottom are right-side up and can be read. Insert the left side of the bottom stand stay
into the side slot [1] of the left stand leg, and insert the right side of the bottom stand stay into the side slot [2] of the right stand leg.
2) Secure the bottom stand stay to the left stand leg and the right stand leg using four M4 hex screws on each side.
3) Hold one end of the stand while a partner holds the other end. Rotate both end of the stand at the same time to stand it upright.
Rotate both ends of the stand simultaneously when standing the stand upright. Rotating only one side before the other may bend the stand and cause problems in
assembly.
[1]
F-3-6
F-3-7
F-3-8
[2]
Chapter 3
0014-8921
3-5