Opening The Cap And Moving The Wiper Unit - Canon imagePROGRAF iPF8000S Service Manual

Chapter 4

4.3.14 Opening the Cap and moving the Wiper Unit

0014-8991
This section explains how to uncap the carriage and ink supply valves manually.
Moving carriage when the power of the printer is off, releasing carriage lock pin and uncapping must be done manually.
1. Uncapping, releasing the carriage lock pin and moving the wiper unit
1) Remove right circle cover (L), right circle cover (S), right side cover and upper right cover.
2) Insert a Phillips screwdriver from the right side into hole [1] in the shaft of the lift unit in the purge unit and turn it counterclockwise. This will lower cap [2] and
lock pin [3], allowing the carriage to be moved.
The wiper unit will move in sync with the motion of the cap and lock pin.
[2]
[3]
[1]
F-4-48
4-30