Filling And Emptying The Well; Resetting The Appliance - Angelo Po 0N1CP1EL User Manual

USE AND OPERATION
Filling
To carry out this operation, proceed as follows.
IMPORTANT: Before filling the tank,
make sure the water drain lever (L) is on
"CLOSED" .
Turn on the water tap (B) for to fill the well
1)
until the minimum level.
Emptying
Turn the water drain lever (L) to "OPEN" to
1)
drain out the water contained in the tank.
IMPORTANT: Empty the well com-
pletely after use .
IMPORTANT: The water drained
from the appliance must pass through a suit-
able drain line, resistant to a temperature of
at least 100°C .
The steam produced when the well is
drained must not come into contact with the
appliance (see also connection diagram at
back of manual) .
If the safety thermostat is tripped, the appli-
ance has to be restored to the initial working
conditions as follows.
Allow the water to cool by 30-40 °C
1)
Open the hatch (A).
2)
Press the button (B) of the safety thermostat
3)
to restore the electricity supply.
Close the door (A) when the operation is
4)
complete.
3320040_ut_GB_rev.3

FILLING AND EMPTYING THE WELL

RESETTING THE APPLIANCE

B
L
CLOSED
OPEN
B
ENGLISH
A
19