Lengthy Downtimes Of Appliance; Servicing; Instructions And Warnings For Servicing - Angelo Po 0N1CP1EL User Manual

ENGLISH
If the appliance is to be out of use for a lengthy
period, proceed as follows.
Cut off the mains electricity supply using the
1)
appliance's master switch.
Turn off the water supply tap.
2)
Clean the appliance and the surrounding ar-
3)
eas thoroughly.

INSTRUCTIONS AND WARNINGS FOR SERVICING

NOTE: Carefully read the hazards men-
tioned in section "Hazards and safety provi-
sions during servicing" on page 9 .
Keep the appliance at peak efficiency by car-
rying out the scheduled servicing procedures
recommended by the Manufacturer. Proper ser-
vicing will ensure the best performance, a longer
working life and constant maintenance of safety
requirements.
WARNING: Before carrying out any
servicing procedure, activate all the safety
devices provided and decide whether staff at
work and those in the vicinity should be in-
formed .
In particular, close the water supply tap, cut
off the electricity supply using the switch dis-
connector and prevent access to all devices
that might cause unexpected danger and
damage to people's health and safety if acti-
vated .
20

LENGTHY DOWNTIMES OF APPLIANCE

SERVICING

Spread a film of edible oil over the stainless
4)
steel surfaces.
Carry out all the servicing procedures.
5)
Cover the appliance and leave a few gaps to
6)
allow air to circulate.
IMPORTANT: Empty the well com-
pletely after use .
Also make sure that during the maintenance
procedure, that the operator is always able to
check whether the plug is disconnected from
the power outlet .
At the end of each session of use and when-
ever necessary, clean:
– The well.
– Accessories.
– The appliance and the surrounding environ-
ment (see page 11).
Every 100 working hours have skilled, author-
ised personnel carry out the following opera-
tions:
– Check that the safety thermostat is working
correctly.
– Check that the electrical system is in good
working order.
SERVICING
3320040_ut_GB_rev.3