Western Digital OpenFlex Data24 Manual page 30

EcoDesign Disclosures
Figure 43: PDB-B Screw Locations
c. Carefully pull PDB-B upward to separate it from its connector on the midplane and remove it
from the Chassis:
Figure 44: PDB-B Removal
Step 19 : Remove power distribution board (PDB) A.
a. Using a T10 Torx screwdriver, remove the two (2) screws holding PDB-A to the side of the
Chassis. The screws are accessed through holes in the side panel of the bay for IO Module
(IOM) A:
Caution: To prevent damage to the PDB leads and midplane connector, do not
twist or torque the PDB when removing it from the midplane.
1. EU EcoDesign Disclosures
1.4 OpenFlex ™ Data24 Disassembly
26