Western Digital OpenFlex Data24 Manual page 26

EcoDesign Disclosures
Figure 35: Rear System LED PCBA Screw Locations
d. On the PCBA, open the connector and separate the LED cable from the PCBA. Remove the
PCBA and leave the cable in place:
Figure 36: Rear System LED PCBA Removal
Step 16 : Remove the fan bracket.
a. Using a T7 Torx screwdriver, remove the eight (8) screws from midway along both sides of
the Chassis, and remove the eight (8) screws from the inside-bottom of the fan bracket (16
screws total):
Note: Removing the fan bracket and IOM bulkhead will allow access to the
midplane and PDBs.
1. EU EcoDesign Disclosures
1.4 OpenFlex ™ Data24 Disassembly
22