Axis W800 User Manual page 14

Axis body worn solution
Configure your system
Recording activation
Feedback
Recording button
Fall detection
Broadcast wireless signal
Receive wireless broadcast
Front recording indicator
Alert
Periodic reminder when recording is on
Periodic reminder when recording is off
Low battery warning
14
• Single press – Starts to
record when the user presses
the button once.
• Double press – Starts to
record when the user presses
the button twice. This setting
also applies to AXIS TW1201
Mini Cube Sensor if it's
connected to the camera.
Starts to record when the camera detects
a fall.
Makes other cameras nearby start to
record when this camera starts to record.
The other cameras must have Receive
wireless broadcast turned on.
Starts to record on this camera when a
nearby camera broadcasts a recording
signal.
The state of the indicator while the
camera is recording:
• None
• Steady
• Flash
When AXIS TW1201 Mini Cube Sensor
is connected, the indicator behavior is
applied to the sensor's front recording
indicator.
Camera feedback through:
• Vibration
• Sound
• Sound and vibration
• Voice
• Voice and vibration
The camera vibrates at regular intervals
while recording. This works as a reminder
as well as a confirmation that the camera
is recording. This is mainly suitable
for incident based recording. Select
a preferred interval for the periodic
reminder.
The camera vibrates and beeps at regular
intervals when recording is off. This is
mainly suitable for continuous recording
since it reminds the user to start recording
again, for example, after taking a break.
Select a preferred interval for the periodic
reminder. Turn on Escalating to gradually
increase the frequency of the reminders.
The camera gives feedback when there is
less than 0.5 hours battery time left.
• Once: The camera beeps and
vibrates once.