Axis W800 User Manual page 18

Axis body worn solution
Configure your system
Set up self-assign camera assignment
Note
• Self-assign camera assignment is selected in the system setup wizard. Changing to fixed camera assignment requires a
system reset.
• This setup requires RFID reader External RFID Card Reader 125kHz + 13.56MHz with NFC (USB). There are two models of
this reader. The model name is printed on the product label:
- TWN4 Multitech is supported by all firmware versions.
- TWN4 Multitech 2 LF HF requires firmware version 10.12 or later.
To set up self-assign camera assignment:
1. Connect the RFID reader to the system controller. Wait for the LED on the reader to light up green, which takes about 15
seconds. The reader now has the correct firmware and is ready for use.
2. To pair each RFID tag individually, continue with next step.
Alternatively, to associate already existing RFIDs with all users at once, see Import users on page 16.
3. Disconnect the RFID reader from the system controller.
4. Connect the same RFID reader to the computer that you use for accessing AXIS Body Worn Manager.
Note
Setup through remote desktop solutions isn't supported. The RFID reader must be connected directly to the computer that
you use for accessing AXIS Body Worn Manager.
5. In AXIS Body Worn Manager, go to
6. Select the user that you want to pair the self-assign tag with.
7. Click
8. Click Pair (Self-assign tag).
9. Tap the self-assign tag on the RFID reader to register it. Keep tapping until all the dots in the user interface turn yellow.
Note
Repeat steps 6–9 if you want to do more than one pairing.
10. Disconnect the RFID reader from the computer.
To watch this video, go to the web version of this document.
help.axis.com/?&piaId=58704&section=set-up-self-assign-camera-assignment
Set up self-assign camera assignment
to pair new equipment.
.
18