Axis W800 User Manual page 13

Axis body worn solution
Configure your system
Pre-buffer
Location
Assisted GNSS (ephemeris) enabled
Overlay
Pre-buffer adds recording time before the recording starts, to ensure that the whole
event is captured.
The pre-buffer has a dedicated space on the camera storage. When you use the
maximum resolution 1080p in very complex scenes with a lot of movement, or in low
light, the pre-buffer memory can get full. If the memory gets full, it results in a
slightly shorter pre-buffer time than configured.
Length
Audio
Stores the camera's geographical position as coordinates.
Don't use indoors.
Increases power consumption.
Power saving mode
Mode
Overlays are superimposed over the video stream. They are used to provide extra
information in the recordings.
User name
User ID
Position
13
Pre-buffer length in seconds: 15, 30,
60, 90, or 120 seconds. The 120 second
option is available only with the 720p
image quality.
Includes audio in the pre-buffer.
Power saving mode limits location mode
to Start and end only. To allow location
mode Track, turn off Power saving mode.
• Start and end – Records
the camera's geographical
position when a recording
starts and ends.
• Track – Continuously
records the camera's
geographical position
throughout the whole
recording. Track mode is
available only if supported by
the content destination.
The name entered when you create a
camera user.
The user ID entered when you create a
camera user.
Shows the camera's geographical position
as coordinates. Requires that Location
is turned on.
If Location > Mode is set to Start and
end, the overlay shows the camera's
position at the start of the recording.
If Location > Mode is set to Track,
the overlay shows the camera's current
position.