Adjusting The Light Barrier For Vertical Tracking; Loading Medium; Loading A Plate Medium With An Automatic Feed Table - Durst Rho 1012 Operating Instructions Manual

E Operation
70 / 147
Collision of the table with the limiting plates!
Damage to the stacking unit
Test the height of the limiting plates before operation. Tighten the
fixing screws only lightly for the test.
Adjust the height as follows:
– Loosen the fixing screws (1).
– Adjust the limiting plate (2) to the desired height.
– Tighten the fixing screws only lightly.
– Test the setting in operation.
– Tighten the fixing screws.

9.5 Adjusting the light barrier for vertical tracking

The vertical position of the light barrier can be adjusted.
Fig. 36 Adjusting the light barrier
1. Loosen the fixing lever (2).
2. Adjust the vertical position with the adjusting screw (1) to the desired
position.
3. Tighten the fixing lever.

10 Loading medium

10.1 Loading a plate medium with an automatic feed
table
Plate media can be loaded in the following operating modes:
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
1
2
Rho 1012/1030