Table of Contents
Advertisement
Rho 1012/1030
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
3.4.2 Adjusting the passing height
The passing height (gap between the front stop and the conveyor belt) has to
be adjusted depending on the thickness of the plate medium.
Fig. 19
Adjusting the passing height
1. Loosen the fixing screw (2).
2. Use the lever (1) to adjust the height of the front stop (3).
3. Tighten the fixing screw.
E Operation
41 / 147
Advertisement
Table of Contents
