Durst Rho 1012 Operating Instructions Manual page 58

E Operation
58 / 147
1. Set the key switch at the printer to 2 (device-change position).
Fig. 29
2. Slide the Heavy Roll Tool 60 into the guide of the printer.
3. Close clamping lock.
4. Connect power cable to the connector on the unwinding unit and to the
connector on the printer.
5. Connect the control cable to the connection on the unwinding and
winding units.
6. Set the key switch at the printer to 1 (normal mode).
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
Sliding the Heavy Roll Tool 60 into the guide and closing
the clamping lock
Rho 1012/1030