Durst Rho 1012 Operating Instructions Manual page 72

Table of Contents

E Operation

72 / 147

10.1.2 Loading a plate medium in semi-automatic mode

For mirror-inverted printing of the rear the front is ﬁrst used with the right

stop, then the rear with the left stop.

✔ In the software Continuous Feeding is activated in the media channel

1. Remove the front stop, if necessary, or adjust it so that drawing-in of the

plate medium is not impaired (→ Page 40 / Adjusting the front stop).

2. Set the feed table at the operator panel to semi-automatic mode.



The pins at the front stop move upward.

3. Load the desired media channel in the software. Take the following into

consideration: If a plate medium is to be printed with left stop (e.g. for

back printing), this option has to be activated in the media channel.

Fig. 38

4. Lay the plate medium as follows on the feed system:

–

Lay the plate medium against the guides (1). By default the guides

(1) on the right-hand side are used, in case of left stop (for example

for back printing) the guides on the left-hand side.

–

Lay the plate medium with the front end against the pin.

5. Start drawing-in at the corresponding operator panel.



The medium is transported automatically to the printer.

Laying the medium against the guides and pins (here: right

stop)

Rho 1012/1030

Table of Contents

Rho 1030