Durst Rho 1012 Operating Instructions Manual page 105

Rho 1012/1030
Board Options
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
 Name
 Media family
 Type: Plate ("board") or roll medium
Fig. 64 Type sub-tab
Depending on whether you press the Boards or Roll Media button under
media type, different buttons appear on the sub-tabs.
4.2.1 Plate media
The following functions are available if you press the Boards button:
You press the Continuous Feeding button if you use the automatic feed
table for serial printing. This enables you to feed in stacks of plate media in
automatic or semi-automatic mode.
Press the Manual Continuous Feeding button, if you use a registration table
and continuously feed a track with plate media manually.
Press the Mechanical Front Stop button when you are feeding in individual
plate media and push the plate media manually to the front stop of the printer.
With the Rows per Batch selection list field you specify the number of rows
after which the feed system is to carry out a forced stop. All the plates
already fed in are first printed completely and transported out of the printer.
Afterwards the measuring system reregisters new the plate edges of the next
batch in order to avoid measuring errors in the image positioning.
Using the Tracks selection list field, you set the number of webs to be printed
next to one another.
With the Board Alignment buttons, you can set whether the plate media are
positioned at the right- or left-hand stop.
F Software
105 / 147