Checking The Temperature Of The Fusion Board; Checking The Quality Of The Signal In The Light Guide - Durst Rho P10 200 Service Manual

3 Diagnostics
Checking the data connection between workstation and Fusion board
If the data LED does not light up, the following are the options for error recovery.

Reboot the workstation.

Restart the printer.

Cables for data transmit and data receipt could be transposed.

Check the fibre optic cable and if necessary exchange it.

Check the SFP modules and if necessary exchange them.

Exchange the fusion base PCB in the workstation or fusion board.
Checking the communication to the printer:
1. In the printer software: Select the Printer tab.
2. Press the Get Version button.
If there is no data connection, an error message is displayed. Otherwise the current
firmware version is displayed.
3.8.4

Checking the temperature of the fusion board

 The fusion board must be booted up correctly ( Chapter 3.8.2, p. 69)
 The data connection must be correct ( Chapter 3.8.3, p. 69)
1. In the printer software: Select the Communication tab.
2. Send serial command
3. Evaluate the response of the printer ( Chapter 3.1.1, p. 14).
3.8.5

Checking the quality of the signal in the light guide

 The fusion board must be booted up correctly ( Chapter 3.8.2, p. 69)
 The data connection must be correct ( Chapter 3.8.3, p. 69)
1. In the printer software: Select the Communication tab.
2. Send serial command
3. Evaluate the response of the printer ( Chapter 3.1.1, p. 14).
Assessing the signal quality via the tab value 117 (response is parameter a):
70
.
QMST
YQSFP
2014 © Durst Phototechnik DIT GmbH, Diagnostics, Edition 09.04.2014

Check that the large data LED on the
fusion base PCB on the Fusion board
light up.

Check that the large data LED(s)
(depending on the number of fusion
boards) on the fusion base PCB in the
workstation light up.
Rho P10 200/250