Durst Rho 1012 Operating Instructions Manual page 71

Rho 1012/1030
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
 Automatic: Loading of thin flexible plate media for serial printing
 Semi-automatic:
– Thin, flexible plate media
– Mirror-inverted printing of the rear
 Manual mode: Plate media with excess length
10.1.1 Loading plate media in automatic mode
✔ In the software Continuous Feeding is activated in the media channel
1. Adjusting the front stop (→ Page 40 / Adjusting the front stop)
2. Set the feed table at the operator panel to automatic mode.
Fig. 37
3. Lay the desired number of plate media stacked on the feed table.
Proceed as follows:
– Lay the first track against the right-hand guides (1).
– Lay all further tracks to the left. Lay the plate media between the
swivel stops in the process.
4. Load the desired media channel in the software.
5. Start printing process in the software.
6. Lay further media on the feed table while the media are being drawn in.
 The media are transported automatically to the printer.
Laying media on the load position
E Operation
1
71 / 147