Adjusting The Front Stop - Durst Rho 1012 Operating Instructions Manual

E Operation
40 / 147

3.4 Adjusting the front stop

The front stop has to be set to the width and thickness of the plate media.
The plate media lying on it are held back. The front stop can be removed
completely, if required, for loading in semi-automatic mode.
3.4.1 Removing the front stop
Fig. 18 Removing the front stop
1. Open the fastening screw (1) on the right- and left-hand side of the feed
table.
2. Remove the front stop (2).
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com, Rho 1012/1030, Issued 07/2013
Rho 1012/1030