5.3.2. Changing DIP Switch Settings
At the front edge of the main module inside the unit there is an 8 position DIP switch, which is used to
select various operational and diagnostic functions. The ON position is down or closest to the PCB. Most
users will have no need to alter the factory switch settings.
DIP Switch
To gain access to the DIP switches you will have to remove the top cover.
Before removing the top cover of the unit make sure that both power cords are
disconnected from the mains.
TECHNICAL DESCRIPTION
HD9010-SIE High Definition Source ID Encoder Manual
Function
1
Not used – set to Off
2
Bypass Option installed
3
Metadata Slave type 1 (Factory use only) – set to Off
4
Enable data broadcast mode for COM 1
5
Not used – set to Off
6
Metadata Slave type 1 (Factory use only) – set to Off
7
Dual power supply option installed
8
Disable debug message output on COM 1
Table 5-1: DIP Switch Functions
Revision 1.2
Page 5-6